Reply To: Send_Payload command failed.

Forum Forums SIGFOX Send_Payload command failed. Reply To: Send_Payload command failed.

#121
joe.hou
Participant

It is most likely that you were using the old version of the Change_To_RCZxx command. The old version defaults to crystal however the new module is equipped with TCXO. To solve this issue, you need to use new version of the command with four additional parameters (TX attenuation steps, XTAL used, Frame repeat count and PA Type).Please refer to “SN10-1x Software Development Guide” available on Innocomm’s website for details.