how can i get a data from a i2c sensor and send it through SIGFOX module?

Forum Forums SIGFOX how can i get a data from a i2c sensor and send it through SIGFOX module?

This topic contains 3 replies, has 3 voices, and was last updated by  lion.wang 2 days, 11 hours ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #614

    Alex Garcia
    Participant

    Hi, everyone.

    I’ve been trying to work with the SN10 SDK + EVB-A 22 but i can figure out, how can i get a data from i2c sensor and send it through SIGFOX module?. I’ve based on “SN10 SDK User Guide V 0.2.5”, unfortunately, this only has a code example (low_power_tracker.c) that when i run the function “sendGPSLocation” the board freez with the trace “Fixing GPS location…”. I was wondering if there are a sdk manual that show me with detail the sdk functions and how can i manipulate the GPIO’S?.

    best regards

    #615

    lion.wang
    Keymaster

    There are no available i2c pin can add sensor to SN10-2X EVB.

    #619

    zuiotec20
    Participant

    Hi, I need to Download SN10 Library SDK because I am Setting up the SDK To use my Sigfox Device.
    Please, could you help me with that, Where can I download this zip or this folder? I need this one to start.

    If you have this one, please send me to my email: zuiotec20@yahoo.com

    Thanks, regards.

    #620

    lion.wang
    Keymaster

    Hi Zuiotec20,

    I already send download link to you.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.