Send_Payload command failed.

Forum Forums SIGFOX Send_Payload command failed.

This topic contains 1 reply, has 1 voice, and was last updated by  joe.hou 1 year, 9 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #120

    joe.hou
    Participant

    I was not able to send Send_Payload, Send_Bit commands. The ACK pin of the module failed to pull low.

    #121

    joe.hou
    Participant

    It is most likely that you were using the old version of the Change_To_RCZxx command. The old version defaults to crystal however the new module is equipped with TCXO. To solve this issue, you need to use new version of the command with four additional parameters (TX attenuation steps, XTAL used, Frame repeat count and PA Type).Please refer to “SN10-1x Software Development Guide” available on Innocomm’s website for details.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.